Page 5
Page 12
User's Manual
User's Manual
Rear Panel
1. Power Switch.
2. Power Cord Receptacle, accepted voltage:90~240V 50/60Hz.
3. RS485 In-Out: RJ45 sockets. Used for transmission of remote control data over long distance
or multiple unit applications.
4. Outputs balance XLR connectors.
5. Inputs balanced XLR connectors.
6. Fan.
2. Preliminary Set-up
1. Design your crossover! To do this, press MENU, and use the BACK or NEXT key to select
‘
Xover
sub-menu
’
and then press ENTER. Use the BACK or NEXT key to select
‘
Program
’
and then
press ENTER.
2. Note that when in a menu, ENTER is always used to confirm selections.
3. Use the EDIT keys on each output channel with the BACK and NEXT keys to select the high pass
filters, low pass filters, parametrics etc. Note that when designing a new crossover, the high and low
pass filters will be set to default values.
4. Use the EDIT keys on each input channel with the BACK and NEX T keys to select the gain, delay
and parametrics available on each input.
5. Setup output channed EQ parameter
6. Setup route of each channel and delay, HPF, LPF, Limit parameter.
Fig 2.4
Fig 2.5
DSC36
DSC36
INPUT A
OUTPUT 4
OUTPUT 3
OUTPUT 1
OUTPUT 2
INPUT C
INPUT B
RS-485
OUTPUT 5
OUTPUT 6
1
2
6
4
5
3
