Page
5
of
18
LP0347
R&G
Unit
1
, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)
1
420 89007 Fax: +44 (0)
1
420 87301 www.rg-racing.com Email: [email protected]
Assembly Of The R&G Tail Tidy
1.
Apply the supplied heat shrink (
Item 10
) or insulating tape to the indicator cables and supplied
number plate illuminator (
Item 3
)
to cover any exposed wires, then attach the CON0013
(
Item4
) to the licence plate illuminator bullet connectors.
2.
Using the 4X M5 bolts, nuts & washers (
Items 5, 6 & 8
) assemble the licence plate bracket
(
Item 2
) with the main mounting bracket (
Item 1
).
3.
Using the supplied heat shrink or insulating tape, apply a small amount to the end of the
indicator wiring cover to stop it from moving. (
Pictures 2 & 3
)
4.
Push the OEM indicator cables through the indicator brackets on the licence plate bracket (
Item
2
), then through the holes in the main mounting bracket (
Item 2)
.
5.
Slide over the OEM nuts and washers, followed by the indicator wiring cover (
Item 9
).
Please note:
The wiring covers may need to be cut at the tapered end in order to fit the
connectors through.
6.
Tighten down the indicator nuts.
7.
Thread the licence plate illuminator (
Item 3
) cables through the licence plate bracket & the
hole in
Item 1
shown in
Picture 1
then add the supplied washers and nuts to the threaded
bars on the back of
Item 3.
8.
Thread the supplied cable ties (
Item 11
) through the slots on
Item 1
shown in
Picture 4
.
Please note:
Do close the cable ties until the tail tidy has been attached and connected to the
OEM wiring.
Attaching The R&G Tail Tidy
1.
Apply the 4X M6 (
Item 7
) washers to the OEM M6 flanged hex head bolts.
2.
With the 4X OEM M6 bolts to hand, offer up the assembly to the motorcycles undertray.
3.
Thread the indicator and licence plate illuminator cables through the wiring hole in the
undertray.
4.
Thread in by hand the bolts one by one until all four are tight enough to keep the assembly in
position.
5.
At this point attach the indicator and licence plate illuminator connectors to the OEM wiring
harness.
6.
Check the operation of the indicators and licence plate lights – and that the LHS and RHS
indicators are in the correct orientation.
7.
Find a suitable position to attach the cables/inline resistors to the underside of the tail bracket.
8.
Tighten down all four bolts evenly
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT LOW DOWN ON THE
LICENCE PLATE MOUNT, THERE IS A POTENTIAL CHANCE THE LICENCE PLATE COULD HIT
THE BACK WHEEL UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR
RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND TAKE AVOIDING ACTION. FAILURE
TO CHECK THIS COULD RESULT IN SERIOUS INJURY.
ISSUE 1 05/10/2022 (TB)
