Page
4
of
18
LP0347
R&G
Unit
1
, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)
1
420 89007 Fax: +44 (0)
1
420 87301 www.rg-racing.com Email: [email protected]
Picture 3
Picture 4
FITTING INSTRUCTIONS
Before fitting the R&G tail tidy you will need to remove some OEM parts. Below is a suggested
list of parts to be removed.
•
Rider seat unit
•
Seat lock mechanism
•
Rear seat
•
Number plate bracket
•
Indicators
•
Indicator and number plate light wiring
Tail Tidy Assembly
Before assembling this product, ensure all the components within the box are correct by
comparing the legend and diagrams.
Removing The OEM Tail Bracket
1.
Remove the rider seat unit via the lock between the rider and passenger seat.
2.
Gently pry away the plastic panel with the seat lock mechanism and move it to one side.
3.
Using an allen key remove the single bolt behind the lock mechanism that holds the rear seat in
place
4.
Remove the two bolts holding the rear seat strap in position or carefully manoeuvre the rear
seat unit through the strap then remove the rear seat unit.
5.
Disconnect the rear indicator and number plate light connectors located under the pillion seat
inside a silicone shroud.
Disassembly Of The OEM Tail Unit
1.
Remove all visible bolts from the tail unit and remove the plastic backing plate.
2.
Once removed the tail units frame should be visible, remove the nut holding the indicators in
place along with any cable ties.
3.
Pull the indicator cables through the frame.
4.
Re-assembly the tail unit without indicators and store.
