Page
11
of
26
LP0286
R&G
Unit 1, Shelley’s Lane, East W
orldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 43
PICTURE 44
FITTING INSTRUCTIONS
•
To fit the R&G tail tidy, first remove the pillion seat using the key as shown in
picture 1
.
•
Undo the bolt arrowed in
picture 2
and remove the rider seat.
•
Remove the cable ties arrowed in
picture 3
and unravel the wiring sheath to allow access to the
plug socket.
•
Disconnect the licence plate illuminator connector arrowed in
picture 4
.
•
Unclip the cable tidy arrowed in
picture 5
.
•
Remove the bolt arrowed in
picture 6
and remove the wiring then replace the bolt.
•
Unclip the wiring as shown in
pictures 7 and 8
.
•
Remove the three bolts arrowed in
picture 9.
•
Remove the four bolts arrowed in
picture 10
and remove the grab handles
.
•
Remove the two bolts arrowed in
picture 11
and remove the under-seat storage box
.
•
Disconnect the four wiring plug sockets for the indicators arrowed in
picture 12
(it is a good idea
to label/identify which male goes into which female socket).
•
Remove the two bolts arrowed in
picture 13
and remove the indicator mounting bracket (please
be careful of the wiring).
•
Remove all the bolts arrowed in pictures
14 thru 24
and carefully remove the seat side panels and
the under-tray.
•
Route the original licence plate illuminator wiring along the rear sub-frame and into the under seat
area (alongside the indicator plug sockets, please ensure when the panels and under-tray are
refitted the wiring is not trapped/over tight) and secure in position using the cable ties supplied
(
item 14
) as shown in
pictures 25 and 26
.
•
Remove the four bolts arrowed in
pictures 27 and 28
.
