Page
13
of
26
LP0286
R&G
Unit 1, Shelley’s Lane, East W
orldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
•
Feed the wires of the new R&G licence plate illuminator (
item 9
) through the central hole in the
new licence plate bracket (
item 1
) as shown in
pictures 35
and
36
.
•
Secure using the washers and nut supplied as shown in
picture 35
.
•
Fit one length of heat-shrink (
item 14
) to the wires and heat gently to shrink to fit.
•
Fit the light shroud and use a small amount of adhesive to hold it in position as shown in
picture
36
.
•
Fit one of the rubber wiring grommets (
item 12
) into the licence plate mounting bracket (
item 1
)
as shown in
picture 37
(a small amount of liquid detergent/soap will aid this process).
•
Place one of the M6 washers (
item 3
) onto each of the M6 bolts (
item 2
), then place the two bolts
and washers through the two holes as shown in
pictures 38, 39 and 40
.
•
Place the two threaded spacers (
item 5
) over the exposed threads and tighten as shown in
picture 39
.
•
Position the spacer (
item 6
) over the hole and hold in position with a small amount of adhesive as
arrowed in
picture 39
.
•
Feed the wire through the grommet as shown in
picture 40
and tidy using the clips and cable ties
(
items 14 and 16
).
•
If using mini indicators blank the remaining holes using the two blanking grommets (
item 17
) as
shown in
picture 41
.
•
Feed the wires through the grommet in the licence plate mounting bracket as shown in
picture 42
(a small amount of liquid detergent/soap will help).
•
Push the licence plate bracket assembly into position and secure using the M5 bolt and washer
(
items 7 and 8
) as shown in
picture 43
.
•
Use the two M6 nuts and washers (
items 3 and 4
) over the exposed threads and tighten as shown
in
picture 44
.
•
Reconnect the licence plate illuminator using the supplied connector (
item13
) to the original plug
socket.
•
If using the original indicators reconnect to the wiring harness as original.
•
If using R&G mini indicators we suggest cutting the original plug sockets from the indicators
(approximately 50mm long) and use the supplied bullet connectors (
item 15
) as shown below to
connect to the original wiring loom.
•
It is a good idea the check the licence plate illuminator and indicators at this stage if illumination
fails please swap the bullet connections around (depending on the choice of indicators you may
have to use resistors to achieve the correct flash rate).
•
Refit the rider/pillion seats as original and licence plate (it may require drilling).
•
IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT FAR DOWN ON THE LICENCE PLATE
HANGER, THERE IS A SMALL CHANCE OF THE LICENCE PLATE HITTING THE BACK WHEEL UNDER HEAVY LOAD
AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND
TAKE AVOIDING ACTION. FAILURE TO CHECK THIS COULD RESULT IN SERIOUS INJURY.
