Instruction Manual – Ramsond CUT series plasma cutters Rev 10-0993
© Copyright Ramsond Corporation. All rights protected. Unauthorized reproduction prohibited.
Page 6
SECTION 3. – GETTING STARTED
3.1 - WIRING
Upon unpacking your Ramsond CUT series plasma cutter, you will notice that the unit is not equipped with
wall plug. This is done to accommodate either the 110V or 220V configuration. The CUT series is a dual
voltage machine. There is no switch for changing the power between 110 and 220 V, as the machine
automatically detects the voltage.
CAUTION
Due to the current draw (Amp), this unit should
NOT
be connected to the standard household 110V outlet.
A 30 Amp circuit is required for 110V operation and a 20 Amp circuit for 220V operation.
The main power cable of the unit consists of 3 wires as follows:
Brown or Red
=
Line
Blue or Black
=
Neutral
Two-Tone Green/Yellow
=
Ground
CAUTION
Incorrect wiring may lead to risk of injury and severe damage to the unit. It shall also
render the limited warranty void!
IMPROPER WIRING OF THE UNIT WILL LEAD TO SUBSTANTIAL DAMAGE TO THE UNIT
AND WILL RENDER THE WARRANTY VOID
.
