Instruction Manual – Ramsond CUT series plasma cutters Rev 10-0993
© Copyright Ramsond Corporation. All rights protected. Unauthorized reproduction prohibited.
Page 7
3.2 - FRONT PANEL
ON / OFF SWITCH
Turns the unit on and off. Digital display may stay lit for up to 1
minute after unit is turned off. This is normal.
DIGITAL AMPERAGE DISPLAY
Displays the Current (Amp). The unit is equipped with a display
calibration screw above the display. If the display is out of range,
adjustments can be made using this screw. For calibrating the
display, turn the Amperage (A) knob to maximum position and
then calibrate the display to the maximum current (e.g. 50A for
CUT50)
AIR CONNECTION
The air hose of the plasma torch attaches to this connection.
Before connecting, ensure connection and threads are clean and
free from debris.
TORCH SWITCH
The electrical connection of the plasma torch connects to this
two-prong connection. Before connecting ensure connection
and threads are clean and free from debris.
GROUND CLAMP CONNECTION
Before connecting ensure connection and threads are clean and
free from debris
CALIBRATION SCREW
Adjusts digital amp display output. To calibrate display turn amp
knob to maximum amperage (e.g. 50 amp for CUT50) and adjust
display to read 50 amps.
