Ramsey Electronics DCY200, Инструкция по монтажу и эксплуатации

Страница: 28 / 30

18. Press bearing (item 24) onto worm and
into worm gear housing. NOTE: Be
sure thick shoulder of bearings outer
race (side with manufacturer’s name
and number) is out, away from worm
threads. Place gasket (item 43) onto
spur gear housing (item 16). Secure
spur gear housing to worm gear
housing using four capscrews (item
33). Torque capscrews to 8 ft. lb.
(10.8Nm). each.
Mount motor (item 51) to spur gear
housing (item 16) using three
lockwashers and nuts (items 39 & 41).
Attach solenoid cables to motor
terminals. Tighten all nuts securely.
19. Place snap ring (item 65) over end of
worm shaft (item 23) and set into snap
ring groove. Insert key (item 19) into
keyway of worm shaft. Place thrust
washer (item 68) over each end of spur
gear shaft (item 21). Set spur gear
shaft assembly into bearing of spur
gear housing. Slide gear (item 12) and
(item 68) thrust washer over end of
worm shaft (item 23).
Insert pins (item 57) into cover (item
91). Place gasket (item 44) onto
cover. Attach cover and gasket to spur
gear housing using twelve capscrews
(item 28). Torque capscrews to 8 ft.lb.
(10.8Nm). each.
Insert plug (item 54) into bottom of
spur gear housing. Permatex may be
applied to threads to help prevent oil
leakage.
Remove reducer and fitting (items 50
& 53) from top of spur gear housing.
Pour ½ pint of SA 20 weight motor oil
into spur gear box. Replace reducer
and fitting into top of spur gear
housing. Tighten reducer and fitting
securely.
28