16. Place thrust washer (item 70) over end
of drum shaft and slide downward until
spacer rests on drum. Press drum
(item 10) downward to compress
springs in gear housing.
Insert keys (item 47) into keyways with
sharp edge of keys pointing outward
and notched end of keys upward. A
rubber or brass mallet will be needed
to gently tap keys into position.
Apply grease to keys and end of shaft.
Place jaw clutch (item 7) over end of
shaft and slide jaw clutch over keys.
Set clutch housing (item 17) over end
of drum shaft. Pull jaw clutch (item 7)
upward, toward clutch housing,
enough to allow yoke, in clutch
housing, to fit properly in groove
around jaw clutch.
17.
Press bearing (item 24) onto worm
(item 23). NOTE; Be sure thick
shoulder of bearings outer race (side
with manufacturer’s name and part
number) is out, away from worm
threads. Press bearing and worm into
gear housing. Slip gasket (item 43)
onto bearing cap (item 6). Use four
capscrews (item 29) to secure cap to
gear housing. Torque capscrews to 8ft.
lb. (10.8Nm) each.
Attach solenoid assembly (item 2) to
gear housing. Use two (item 34)
capscrews and three (item 30)
capscrews with three flat washers
(item 40). Tighten capscrews to 8 ft.
lb. (10.8Nm). each Insert plug (item
56)
into tapped hole of cover.
Permatex may be applied to threads
to help prevent oil leakage. TIGHTEN
plug securely.
27
Содержание DCY200
Страница 14: ...14...
