RAMMER 255E, Руководство оператора

Страница: 22 / 68

COPYRIGHT © 2020 SANDVIK MINING AND CONSTRUCTION OY Page 22 - Operation
Safety 255E
EQUIPMENT CONDITION
Defective equipment can injure you or others. Do not operate equipment which is
defective or has missing parts.
Make sure the maintenance procedures in this manual are completed before using
the product.
REPAIRS AND MAINTENANCE
Do not try to do repairs or any other maintenance work you do not understand.
MODIFICATIONS AND WELDING
Non-approved modifications can cause injury and damage. Contact your local
dealer for advice before modifying the product. Before welding on the product
while it is installed on the carrier, disconnect the carrier alternator and battery. Note
that welding of the hammer tools will render them useless and make the warranty
void.
METAL SPLINTERS
You can be injured by flying splinters when driving metal pins in and out. Use a
soft-faced hammer or drifts to remove and fit metal pins, such as bucket pins.
Always wear safety glasses.
LABELS ON THE PRODUCT
Safety labels communicate the following four things:
■
The severity level of the risk (that is, signal word "DANGER" or
"WARNING").
■
The nature of the hazard (such as high pressure, or dust).
■
The consequence of interaction with the hazard.
■
How to avoid the hazard.
You must ALWAYS follow the instructions of the safety messages and symbols of
the product safety labels and the instructions set forth in the manuals to avoid death
or severe injury!
Keep the safety labels clean and visible at all times. Check the condition of safety
labels daily. Safety labels and instructions which have disappeared, been damaged,
painted over, come loose or do not meet the legibility requirements for safe viewing
distance, must be replaced before operating the product.
If a safety label is attached to a part that is replaced, install a new safety label on the
replacement part. If this manual is available in your language, then the safety labels
should be available in the same language.