RAM Chassis CAB 4500 2016, Руководство пользователя

Страница: 132 / 228

5. At the garage door opener motor (in the garage), locate the “LEARN” or
“TRAINING” button. This can usually be found where the hanging antenna wire
is attached to the garage door opener motor. Firmly push and release the
“LEARN” or “TRAINING” button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has
been pushed.
6. Return to the vehicle and push the programmed HomeLink button twice (holding
the button for two seconds each time). The EVIC/DID will display “CHANNEL #
TRANSMIT”. If the garage door opener/device activates, programming is com-
plete.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to
complete the training.
7. To program the remaining two HomeLink buttons, repeat each step for each
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the
HomeLink button you wish to program while keeping the HomeLink indicator light
in view.
3. Simultaneously push and hold both the HomeLink button you want to program
and the hand-held transmitter button.
4. Continue to hold both buttons until the EVIC/DID display changes from “CHAN-
NEL # TRAINING” to “CHANNEL # TRAINED”, then release both buttons.
5. Push and hold the programmed HomeLink button and observe the indicator light.
NOTE:
If the EVIC/DID displays “DID NOT TRAIN” repeat from Step 2.
• To program the two remaining HomeLink buttons, repeat each step for each
remaining button. DO NOT erase the channels.
E L E C T R O N I C S
130