RAM 2500 2023, Руководство пользователя

Страница: 82 / 468

80 GETTING TO KNOW YOUR VEHICLE
C
ARGO
C
AMERA
— I
F
E
QUIPPED
Your vehicle may be equipped with the Cargo Camera that
allows you to see an image of the inside of the pickup box.
The image will be displayed in the Uconnect screen.
The Cargo Camera is located in the bottom center area of
the Center High Mounted Stop Lamp (CHMSL).
A touchscreen X button to disable display of the camera
image is made available when the vehicle is not in
REVERSE gear.
A display timer is initiated when the Cargo Camera image
is displayed. The image will continue to be displayed until
the display timer exceeds 10 seconds and the vehicle
speed is above 8 mph (13 km/h) or the touchscreen
X button to disable display of the Cargo Camera image is
pressed.
Cargo Camera With Dynamic Centerline (Available With
Surround View Camera Only) — If Equipped
The Dynamic Centerline feature provides an overlay on the
Cargo Camera display screen that aligns to the center of
the pickup box to aid in hooking up a fifth wheel camper or
gooseneck trailer. The centerline auto aligns to the center
of the pickup box, and can also be manually adjusted. The
centerline will adjust in response to steering angle inputs,
and will not obstruct the gooseneck receiver or an
approaching trailer gooseneck in the camera feed.
Activation
The Dynamic Centerline feature can be activated through
the Uconnect Settings by pressing the Cargo Camera
button, followed by the Adjust Centerline button on the
touchscreen.
If the Dynamic Centerline feature is turned on, the overlay
will display anytime the Cargo Camera image is displayed.
Adjusting Centerline
Refer to the following steps to manually adjust the
centerline:
1. Press the Adjust Centerline button located in the
bottom right corner of the Cargo Camera display.
2. Use the arrows on the bottom left corner of the Cargo
Camera display to adjust the centerline horizontally
or vertically.
3. Once the desired position is achieved, press the
Accept button to set the centerline to the newly
specified position.
Deactivation
The Dynamic Centerline feature will automatically be
deactivated whenever the Cargo Camera display is
deactivated. It can also be manually deactivated through
the Uconnect Settings
Ú
page 226.
NOTE:

If the vehicle speed remains below 8 mph (13 km/h),
the Cargo Camera image will be displayed continuously
until the touchscreen X button to disable display of the
Cargo Camera image is pressed.

The touchscreen X button to disable the display of the
camera image is made available ONLY when the
vehicle is not in reverse.
 If snow, ice, mud, or any foreign substance builds up on
the camera lens, clean the lens, rinse with water, and
dry with a soft cloth. Do not cover the lens.
Turning Cargo Camera On Or Off —
With Uconnect 5/5 NAV
1. Press the Controls button located on the bottom of
the Uconnect display.
2. Press the Cargo Camera button to turn the
Cargo Camera system on.
NOTE:
Once initiated by the Cargo Camera button, the Cargo
Camera image will be displayed until the vehicle speed
remains below 8 mph (13 km/h) and the 10 second timer
runs out. The image may be deactivated by pressing the
touchscreen X button, placing the ignition in the OFF
position, placing the gear selector in PARK, or pressing the
touchscreen X button. On deactivation, the previous
selected screen will appear.
A touchscreen button to indicate the
current active camera image being
displayed is made available whenever
the Cargo Camera image is displayed.
A touchscreen button to switch the
display to rear view camera image
is made available whenever the
Cargo Camera image is displayed.
23_DJD2_OM_EN_USC_t.book Page 80