GETTING TO KNOW YOUR VEHICLE
45
NOTE:
If the indicator light stays on constantly,
programming is complete and the garage
door/device should activate when the
HomeLink® button is pressed.
To program the two remaining HomeLink®
buttons, repeat each step for each
remaining button. DO NOT erase the
channels.
If you unplugged the garage door opener/device
for programming, plug it back in at this time.
Reprogramming A Single HomeLink® Button
(Canadian/Gate Operator)
To reprogram a channel that has been
previously trained, follow these steps:
1. Place the ignition in the ON/RUN position.
2. Press and hold the desired HomeLink®
button until the indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button, proceed with
“Canadian/Gate Operator Programming”
step 2 and follow all remaining steps
EXTERIOR LIGHTS
H
EADLIGHT
S
WITCH
The headlight switch is located on the left side
of the instrument panel. The headlight switch
controls the operation of the headlights,
parking lights, instrument panel lights, cargo
lights and fog lights (if equipped).
Headlight Switch
Headlight Switch (Vehicles Sold In Canada Only)
NOTE:
Vehicles sold in Canada are equipped with a
headlight switch without the O (off) position. In
order to turn the exterior lights off, the headlight
switch must be rotated to AUTO position.
To turn on the headlights, rotate the headlight
switch clockwise to the headlight position. When the
headlight switch is on, the parking lights, taillights,
license plate light and instrument panel lights are
also turned on. To turn off the headlights, rotate the
headlight switch back to the O (off) position.
1 — Rotate Headlight Control
2 — Push Cargo Light Switch
3 — Push Fog Light Switch
4 — Dimmer Control
1 — Rotate Headlight Control
2 — Push Cargo Light Switch
3 — Push Fog Light Switch
4 — Dimmer Control
2
21_DS_OM_EN_USC_t.book Page 45
