16
GETTING TO KNOW YOUR VEHICLE
(Continued)
programmed to the vehicle can be used to start
and operate the vehicle. The system cannot
reprogram a key fob obtained from another
vehicle.
After placing the ignition switch in the ON/RUN
position, the vehicle security light will turn on for
three seconds for a bulb check. If the light
remains on after the bulb check, it indicates
that there is a problem with the electronics. In
addition, if the light begins to flash after the
bulb check, it indicates that someone
attempted to start the engine with an invalid key
fob. In the event that a valid key fob is used to
start the engine but there is an issue with the
vehicle electronics, the engine will start and
shut off after two seconds.
If the vehicle security light turns on during
normal vehicle operation (vehicle running for
longer than 10 seconds), it indicates that there
is a fault in the electronics. Should this occur,
have the vehicle serviced as soon as possible by
an authorized dealer.
All of the key fobs provided with your new
vehicle have been programmed to the vehicle
electronics
IGNITION SWITCH
I
GNITION
N
ODE
M
ODULE
(IGNM)
The Ignition Node Module (IGNM) operates
similar to an ignition switch. It has four
operating positions, three with detents and one
that is spring-loaded. The detent positions are
OFF, ACC, and ON/RUN. The START position is a
spring-loaded momentary contact position.
When released from the START position, the
switch automatically returns to the ON/RUN
position.
Ignition Switch
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
1 — OFF
2 — ACC (Accessory)
3 — ON/RUN
4 — START
WARNING!
Before exiting a vehicle, always come to a
complete stop, then shift the automatic
transmission into PARK, apply the parking
brake, place the engine in the OFF position,
remove the key fob from the vehicle and
lock your vehicle. If equipped with Keyless
Enter-N-Go, always make sure the keyless
ignition is in OFF position, remove the key
fob from the vehicle and lock the vehicle.
21_DS_OM_EN_USC_t.book Page 16