Ralink 11G Series, Руководство пользователя

Страница: 51 / 60

Wireless 54 Mbps PCI Card
49
2. A Home Internet Network with Multiple IP Addresses
(Network administrators with Static IPs can also follow these instructions.)
If you have two or more computers (laptops or desktops) and want to share files, printers,
and Internet access using multiple IP addresses that you have purchased from your
Internet Service Provider -or- you want to connect to an Ethernet network that uses Static
IP Addresses, then follow the instructions on the next page. When you have completed
your network, it should look similar to this:
Please note that this type of installation requires that your ISP (Internet Service Provider)
provide you a static IP address for each computer and the Access Point on your network.
Please refer to the manual that came with your Access Point to determine its configuration.
Please follow these steps to complete the installation:
1. Connect the Wireless Access Point to a Broadband connection (i.e., a Cable modem or a
DSL modem.)
2. Install The Wireless 54Mbps PC/PCI Card in the computer(s) on your wireless network
3. Check the Device Manager to confirm that the wireless adapter is installed correctly.
Please refer to the Networking Basics section in this manual entitled, “Checking the
Installation of the Drivers for the Wireless Adapter.”
4. Set the Static IP Address of the wireless adapters if Multiple Dynamic IP are not used.
Note: The IP Address for all computers must be in the same IP Address range, and the Subnet Mask
must be the same for all the computers on the network. For example, if the first computer is
assigned an IP Address of 10.0.0.2 with a Subnet Mask of 255.0.0.0, then the second computer can
be assigned an IP Address of 10.0.0.3 with a Subnet Mask of 255.0.0.0, etc.
Note: If you are using a PPPoE client (Point to Point Protocol over Ethernet), please contact your ISP
(Internet Service Provider) for further instructions regarding connecting to the Internet.
3. An Ad Hoc Network