RAIS 2:1, Инструкция по установке, использованию и техническому обслуживанию

Страница: 11 / 36

ENGLISH RAIS - manual for Rais 2:1
11 April 2014
Installation of stove:
NOTE ! A decision must be made concerning the positioning of the inlets and outlets of
the convection system. Discolouration of the wall above the doors and the
convection air outlets may occur due to convected hot air.
RAIS cannot take responsibility for any building work or consequential damage.
The stove should be inspected for defects at receipt.
Lift the stove from the pallet to the place of installation on to a suitably protected floor. The
socket delivered with the stove corresponds with the minimum installation height.
If the stove is installed in a higher position, adjustable extensions can be used.
Accessories are available to order from your Rais dealer / stockist.
Using a spirit level against the door and body of the stove, ensure that the stove is
perfectly level and make adjustments using the levelling bolts in the base.
Remove the frame and door from the stove. Be careful not to damage the glass or paint.
Leave the protective tape and plastic on the handles during installation.
Seal the flue pipe on to the flue outlet using fire cement and self tapping screws and
connect to the chimney.
Connect the convection air ducts, if required.
The stove is now ready to be built in using either stud walls or solid walls.
When the walls have been finished and decorated, the frame and door can be re-fitted.
Remove all protective plastic and tape prior to commissioning.
The frames are adjusted to the maximum wall thickness at the factory.
The frames can be adjusted from 466mm minimum to 480mm maximum.
Open the door and loosen the bolts at the top and bottom, then gently push the frame
back towards the wall.
Check that the frames are parallel to the walls and the doors in the closed position, adjust
if necessary.
Re-tighten the bolts at the top and bottom.
Made to measure frames are available to order with the stove from your Rais dealer /
stockist.