Rain Bird WS-PRO2, Инструкция по установке, эксплуатации, техническому обслуживанию и устранению неисправностей

Страница: 47 / 113

The following components are provided in the radio kit for installation inside the WS-PRO2
enclosure:
(1) spread spectrum radio
(1) internal antenna cable
(1) enclosure mounting bracket
The radio comes mounted to the enclosure bracket. Install the assembly as follows.
NOTE:
Power the station down by moving the PS150 power switch to the Off position before
installing any communications option. Remember to move the switch back to the On position
after installing the enclosure.
1. Mount the bracket and radio inside the enclosure using the three existing screws ( FIGURE
6-26 (p. 43)).
2. Thread the smaller SMA connector end of the internal antenna cable underneath the
battery cables and screw it to the RF antenna connector on the radio.
3. Attach the other end of the cable to the BNC RF bulkhead connector in the lower right
corner of the enclosure. Make sure all connections are tight ( FIGURE 6-26 (p. 43)).
FIGURE 6-26. Radio mounted in the WS-PRO2 (battery not shown)
4. Connect the long 9-pin female end of the ribbon cable to the CS I/O port on the radio.
5. Screw the connector to the radio using the provided two screws ( FIGURE 6-27 (p. 44)).
Section 6. Installation 43