1
2; 4; 6; 8
3
10
Timing mode configuration of the second output and channel
assignment:
1- Display your desired channel on your transmitter.
2- Press and then release the SW1 push-button on the receiver.
3- The L1 LED turns on for several seconds.
4- Hold down the SW1 push-button.
5-The L2 LED turns on and then goes off.
6- Release the SW1 push-button.
7- The L2 LED begins to flash. Each flash corresponds to a
duration indicated in the above chart.
8- Count the number of flashes. Press the SW1 push-button again
when the number of flashes corresponds to your desired
duration.
9- The L2 LED will remain on for 5 seconds.
10- During this time, press the top arrow key on the transmitter
and hold it down until the L2 LED goes out.
Test operation in the timing mode: Display the previously stored
channel on the transmitter. Press the top arrow key. Relay #2
(terminals 5-6) and the L2 LED will remain activated for the
programmed duration.
5; 7; 9
13
