Number of
Duration
Number of
Duration
Flashes
Flashes
1
1s
16
30s
2
2s
17
1min
3
3s
18
1,5min
4
4s
19
2min
5
5s
20
2,5min
6
6s
21
3min
7
7s
22
3,5min
8
8s
23
4min
9
9s
24
4,5min
10
10s
25
5min
11
11s
26
5,5min
12
12s
27
6min
13
13s
28
6,5min
14
14s
29
7min
15
15s
30
7,5min
31
Bistable
TIMING MODE
1
2; 4; 6 3; 5; 7; 8
8
Timing mode configuration of the first output and channel
assignment:
1- Display your desired channel on your transmitter.
2- Press and hold down the SW1 push-button on the receiver.
3- The L1 LED turns on for several seconds and then turns off.
4- Release the SW1 push-button.
5- The L1 LED begins to flash. Each flash corresponds to a
duration indicated in the above chart.
6- Count the number of flashes. Press the SW1 push-button again
when the number of flashes corresponds to your desired duration.
7- The L1 LED will remain on for 5 seconds.
8- During this time, press the top arrow key on the transmitter
and hold it down until the L1 LED goes out.
Test operation in the timing mode: Display the previously stored
channel on the transmitter. Press the top arrow key. Relay #1
(terminals 3-4) and the L1 LED will remain activated for the
programmed duration.
The chart below is important. It is used to set the timing mode duration during programming.
12
