Tips on wiring the universal receiver relay outputs:
* Used for an automatic gate or garage door (diagram A): Connect the universal receiver relay
output to the push-button terminal on the device's electronic control panel. If the terminal is
already used for a push-button, wire the relay outlets in parallel to the push-button. Important:
configure the output in the pulse command mode.
* Used for lighting operated by a switch (diagram B) : Connect the relay output in parallel to the
switch. Make sure that the power consumed by the lighting is lower than the maximum relay
capacity (2000W). Configure the output in the bistable or timing mode.
* Used for lighting operated by a latching switch (diagram C) : Connect the relay output on the
universal receiver in parallel to a push-button or directly to the push-button terminal on the
latching switch. Configure the output in the pulse command mode.
A
B
C
Automatic gate
electronic panel
External push-button terminal
Before
Before
After
After
After
Existing
switch
Existing
Push-
b tt
10
