RAIMONDI BERTA ADV, Руководство пользователя

Страница: 8 / 15

BERTA ADV ELECTROSPONGE ENGLISH
8
Replacing the sponge roller
BEFORE PERFORMING ANY OPERATION, MAKE SURE THAT THE MACHINE IS UN-
PLUGGED.
REMOVING THE SPONGE ROLLER
Shift the lever (A) to its upright position (figure 2 – page 6).
Move to the side opposite the motor casing.
Raise the handle (E – figure 8) and remove the quick release
device (F – figure 8).
Move to motor casing side. Using a screwdriver, raise the han-
dle (G – figure 9) and remove the quick release device (H – fig-
ure 9).
FITTING A NEW SPONGE ROLLER
Shift the lever (A) to its upright position (figure 2 – page 6).
Place the sponge roller into its seat, keeping the side featuring
the hexagonal notch on the right.
When fitting the roller, make sure the rubber water sealing plugs
are facing upwards.
Move to motor casing side.
Fit the quick release device and the hexagonal pin (H – figure 9)
Turn the sponge roller by giving it short and light presses (for-
wards and backwards as shown in figure 10) whilst holding
down the quick release device (H – figure 9), until it fits perfectly
into the hexagonal notch of the roller.
Move to the side opposite the motor casing.
Fit the quick release device with its cylindrical pin (F – figure 8).
IMPORTANT: QUICK RELEASE DEVICES (F/H – FIGURES 8/9) MUST FIT PERFECTLY INTO
THEIR HOUSINGS.
F
IG
. 8
F
IG
. 9
F
IG
. 10
E
F
G
H
G