RAIMONDI BERTA ADV, Руководство пользователя

Страница: 6 / 15

BERTA ADV ELECTROSPONGE ENGLISH
6
Preparing the machine
Before using the machine to clean a floor, moisten the sponge.
Fill the tank with about 15 litres of cold and clean water.
Shift the lever (A) to its upright position (figure 2).
Operate the switch and let the sponge roller run for about 30
seconds.
Shift the lever (A) back to its horizontal position (figure 3).
The machine is now ready for use.
Using the machine
Before performing cleaning operations, make sure that
the sealant has sufficiently settled.
If the sealant has hardened on the tile surface, wet the
floor and emulsify the sealant with a brush and felt pad.
NEVER INCREASE PRESSURE ON THE SPONGE
ROLLER BY PUSHING THE HANDLE UPWARDS.
Return to the beginning of the area to clean with the
sponge roller in its raised position.
To do so, hold the machine's handle down.
Lower the sponge roller to the floor and start moving
slowly backwards, preferably in a diagonal manner with
respect to the tile installation direction.
By doing so, you will perfectly clean the tiled surface
from any grouting material.
Once you have reached the end of the area to clean,
raise the sponge roller, turn the machine and return to
the beginning of the area to clean.
Lower the sponge roller so that it overlaps the area previously treated by about 5 cm (figure 4).
When cleaning close to room walls, make sure that the motor guard does not come into contact with the
wall.
If foam forms in the tank during use, add a few drops of an anti-foam product.
F
IG
. 2
F
IG
. 3
F
IG
. 4
A
A