The marker lights for the tender can be replaced following the same procedure
use for the engine.Remove the six screws that attach the tender body to the tender
frame as shown in fig. 8b.
To replace the Tender Marker LEDs:
1. Unplug the yellow connector in the rear of the tender shell. See fig. 8b
2. Gently pull on the wires from the
bottom of the marker housings and
through the rear of the tender shell.
3. Gently thread the new LEDs through the
rear of the tender shell and into the marker
light housing.
4. Reconnect the yellow connector.
Cab Interior Light:
1. Unplug the black connector at the rear
of the boiler shell. See fig. 8a
2. Gently pull on the wires to remove the
light bulb from the backhead.
3. Gently push the new light bulb into the
backhead.
4. Reconnect the black connector.
Firebox Glow Lights:
1. Unplug the black connector at the rear of the engine chassis. See fig 9.
2. Gently pull on the wires to remove the light bulbs from the bracket.
3. Gently push the new light bulb into the bracket.
4. Reconnect the black connector.
After replacing the light bulbs replace the boiler shell and the 6 screws. Be careful
not to pinch any wires when placing the boiler shell back on the chassis.
To access Tender Marker
LEDs
Firebox Lights
Rail King 4-6-6-4 Challenger
15
Figure 8b
Figure 9
