Raider RD-T12, Руководство пользователя, Страница: 32 / 94

32 www.raider.bg
Start the engine carefully as instructed and with your feet far from the blade.
Do not tilt the machine when starting the engine. Start the machine on a level surface. Keep your hands and
feet away from rotating parts.
TO STOP THE ENGINE:
1.After the last treatment, let the appliance run for 1-2 minutes. The engine will cool
a little.
2. Adjust throttle lever to “STOP” position (if equipped), adjust switch
to switch engine on / off in position “0” (if equipped)
3. Disconnect and ground the spark plug wire to prevent accidental starting,
while the equipment is unattended.
CHANGE IN BORDERS:
- unlock the locking pin, remove the installed coulter
- Replace with the new coulter and secure the safety pin again
- Do the same on the other side
Always replace both pairs of teeth at the same time to avoid
damage to the tool from the imbalance.
WORKING SPEED:
Adjust the throttle control lever to “Max. speed ”for best machine performance. The throttle must be set
to control forward movement to a slow walking speed for cultivation. Insert the throttle control lever into the
Min. speed “to reduce motor voltage when no machining is performed. In addition to adjusting the depth of the
regulator, changing the pressure on the handles also helps to further regulate the depth and speed of travel. The
downward pressure on the handles will reduce the depth of processing and increase the speed of travel. Pressing
up on the handles will increase the working depth and reduce the speed of travel.
CONNECTOR CONTROL:
Pushing down to drive the teeth forward. The release returns the machine to neutral.
DEPTH REGULATOR:
It serves a dual purpose. It adjusts the processing depth and helps the operator control the direction and
speed of control.
Expand the wheel clamp to raise the wheels to one of the high positions.
Lowering the depth control lever will slow the machine down and make it work deeper. Increasing the depth of
the regulator will allow it to move faster and shallower.
Do not adjust the depth of treatment unless the clutch control lever is released in the neutral position.
Switch off the engine before operating the machine. Wait for all moving parts to stop completely.
TO ADJUST THE DEPTH OF PROCESSING:
Remove the locking screw.
2. Raise or lower the depth control lever.
3. Align the depth regulator groove with the holes in the bracket
lock and
insert the retaining screw.