14
www.raider.bg
To clean the inlet air can not use solvents for paint, gasoline and other strong solvents.
Lubrication of the machine is made by pouring grease duct and passing through the inside by
shaking the instrument.
It is advisable to clean the main unit once a week.
WARNING! For longer technical life of your machine just follow the manufacturer’s instructions.
Before working note of the technical characteristics of the instrument and instructions for use.
5. Possible issues and recommendations
Problems:
- Can not reach normal operating speed
- blocking the motor
- Departure for release lever for inclusion
- deceleration
- vibration outside normal
- heating the body of the machine
Reasons:
- not enough air supply
- failure of the rate
- wear the rotor
- dusty bike
- failure of the trigger mechanism
- air leaks
- damaged bearings
- displacement of the O-ring
- not well-oiled machine
Recommended course of action:
- Check the hose is not blocked, jammed or bent
- Check the performance of compressor
- replace the rotor
- Disassemble the unit and clean it
- Check and adjust the trigger mechanism
- Stop the end of the air
- Replace bearings
- Fit the correct O-rings and replace damaged
- Constantly lubricate the unit.
SAFETY INSTRUCTIONS
Warning! Using this pneumatic device Always follow the basic rules for safe work and described
in this guide for further safety measures to avoid possible risk of fire, electric shock or injury. Read