Raider R50ES-001, Руководство пользователя

Страница: 34 / 78

SECTION 2
Owner’s Manual Standard Operating Procedures
24
P
RE
-O
PERATIONS
C
HECKS
Exterior . Inspect Cowling, Engine Pan, Midsection, and Lower Unit for cracks, defects, or damage.
Zinc Anodes. Stern Brackett Anode. Replace if damaged or reduced in size by more than 40%.
Trim Tab Anode. Replace if damaged or reduced in size by more than 40%.
Control Panel. Inspect the Start and Stop controls. Verify the Lock Plate and Lanyard are installed.
Inspect for damage due to corrosion, lack of maintenance, or abuse. Loose ball joints, locknuts,
bent link rods, loose rod snaps.
Cable Lanyard . Verify the Cable Lanyard is securely attached to the motor and maybe securely
attached to craft Transom.
Shift Lever Mechanism and Shift Lever Stopper . Inspect for damage due to corrosion, lack of
maintenance, or abuse. Loose ball joints, locknuts, bent link rods, loose rod snaps.
Throttle Linkage . Inspect for damage due to corrosion, lack of maintenance, or abuse. Loose ball
joints, locknuts, bent link rods, loose rod snaps. Lubricate with low temperature lithium grease.
Tilt Stopper, Bracket Bolt, Bracket Shaft, Clamp Screw, and Reverse Lock . Inspect for damage due
to corrosion, lack of maintenance, or abuse. Lubricate with Friction Surface Marine Grease.
Hook Lever Mechanism (cowling) . Inspect for damage due to corrosion, lack of maintenance, or
abuse. Lubricate with Friction Surface Marine Grease.
Recoil Starter . Inspect for damage due to corrosion, lack of maintenance, or abuse. Lubricate
with Friction Surface Marine Grease.
Starter Lock . Inspect for damage due to corrosion, lack of maintenance, or abuse. Lubricate with
Friction Surface Marine Grease.
Battery . Inspect battery case for damage. Inspect cables for cracks, chaffing and insulation
damage. Check battery mounting. Inspect battery connector for corrosion. Lubricate battery
connector with dielectric grease.
Electrical Wiring . Inspect wires for cracks, chaffing and insulation damage. Check for loose
connections.
Ignition Coil Plug Wire Boots . Prior to submersion, remove plug boots and fill with dielectric
grease.
Gearcase . Inspect water intake screens. Inspect the Skeg for damage.
Propeller . Inspect and verify propeller is true and free of nicks, chips, and other damage that
could affect performance. Propeller Shaft. Inspect for damage due to corrosion, lack of
maintenance, or abuse. Inspect the shaft threads and splines for wear and damage.