Rage SUPERCAT 700BL, Инструкция по эксплуатации

Страница: 9 / 18

9
Throttle Ratio Switch
Throttle Ratio
Switch set to 7:3
To safely operate the SuperCat 700BL, the switch
on the top of the transmitter has been fixed in the
7:3 position, so that you should be able to read the
7:3 above the switch location. If, for any reason,
the switch is not in this position, you MUST move it
before operating the boat. It is important to never
move the switch from the position where you can
read 7:3.
WARNING: The switch on the top of the transmitter
should arrive fixed in location so that it can never be
moved. It is important to NEVER move this switch
from this location or the throttle could engage the
propeller when the transmitter is turned on and
potentially cause personal harm or injury.
Throttle Trim
Throttle Trim
The throttle trim dial is used to adjust the throttle
trim when the throttle stick is released (neutral
position). This is typically used to adjust the brakes.
Rotating the dial causes the throttle trim (the throttle
position at rest) to be changed.
Steering Trim
Steering Trim
The steering trim button is used to adjust the steering
trim when the wheel is centered.
Pushing the button to the right or left changes the
steering trim (the steering at rest position). Normally,
the steering trim is adjusted until the vehicle tracks
straight.
Receiver Connection and Binding
Binding is the process of programming the receiver to
recognize the GUID (Globally Unique Identifier) code
of a single specific transmitter. When a receiver is
bound to a transmitter, the receiver will only respond
to that specific transmitter. If you need to rebind for
any reason, please follow these steps:
1.
With the transmitter switched OFF Insert the
bind cable to bind channel slot.
FailSafe Bu�on
Bind Cable
Antenna
2. Power on the receiver by plugging the battery
into the ESC, then turn on the transmitter. Press
the bind button within 5 seconds.