Rage SUPERCAT 700BL, Инструкция по эксплуатации

Страница: 15 / 18

15
Rudder does not move Rudder, linkage or servo damage Replace or repair damaged parts and adjust con-
trols
Wire is damaged or connections are
loose
Do a check of wires and connections, connect
or replace as needed
Transmitter is not bound correctly or
the incorrect model was selected
Re-bind or select correct model in transmitter
BEC (Battery Elimination Circuit) of the
ESC is damaged
Replace ESC
ESC switch is off Power on ESC switch
Controls reversed Transmitter settings are reversed Do the Control Direction Test and adjust controls
on transmitter appropriately
Motor or ESC overheats Blocked water cooler tubes Clean or replace water tubes
Motor power pulses
then motor loses power
ESC uses default soft Low Voltage Cut-
off (LVC)
Recharge boat battery or replace battery that is
no longer performing
Weather conditions might be too cold Postpone until weather is warmer
Battery is old, worn out or damaged Replace battery
Battery C rating might be too small Use recommended battery
Replacement Parts List
Need spare parts? Contact your local hobby shop or place of purchase. If unavailable, contact Rage RC direct at
(800) 860-3709 or visit www.hobbyrecreationproducts.com.
Part Number Part Description
RGRB1207 SuperCat 700BL RTR Catamaran Boat
RGRB1245 Painted/Decorated hull
RGRB1246 Painted Canopy
RGRB1247 Canopy Latch
RGRB1248 3540/2000KV Brushless Motor
RGRB1249 Stainless Steel Motor Mount
RGRB1250 Brushless Motor Coupler
RGRB1251 40A Brushless ESC (Water-Cooled)
RGRB1252 11.1V 3S 25C 3600mAh LiPo Battery with T-Plug
RGRB1253 40g Rudder Servo
RGRB1254 Rudder Pushrod Set (2)
RGRB1255 Stainless Steel Shaft Bracket
RGRB1256 Flex Drive Shaft
RGRB1257 Stainless Steel Propeller (3)
RGRB1258 Silicone Tubing
RGRB1259 Water Outlet Plug
RGRB1260 Stainless Steel Rudder Assembly
RGRB1261 2.4Ghz 2 Ch. Transmitter
RGRB1236 2.4Ghz 2 Ch. Receiver