Rage SUPERCAT 700BL, Инструкция по эксплуатации

Страница: 10 / 18

10
BIND BUTTON
3. Release the bind button and wait for about 5
seconds.
4. After the receiver LED stops flashing binding is
complete.
5. Unplug the bind cable and you are ready to run.
CAUTION: DO NOT leave the bind cable in the bind
channel plug after binding is finished, otherwise the
binding program will work automatically each time
when you power on the receiver.
Failsafe Setting
The SuperCat 700BL comes with the receiver failsafe
set to NONE. In the event of loss of signal the motor
will stop and the vehicle will drift. If the signal is
regained, normal function will return. If you wish to
program the failsafe to a custom setting, just follow
these simple steps:
1.
With both the transmitter and receiver
powered ON, press the bind button on the
receiver for about 3 seconds.
2. The receiver will enter failsafe setting menu and
the receiver LED will flash.
3. You have about 3 seconds to move the controls
to the position that you wish to program into
failsafe.
4. After the 3 seconds the receiver will save the
settings and return to normal mode.
5. If you wish to reset to a different setting, simply
repeat above steps.
How to Operate Your Vehicle
• Throttle
Forward
Off
Pull the trigger towards you to make the vehicle go
forward.
The proportional speed control means the farther you
pull it the faster the vehicle will go.
Release the trigger to stop. Adjust the trim if the
motor does not stop when the trigger is released.
• Steering
Right Le�
Rotate the steering wheel clockwise while holding the
trigger to turn right.
Rotate the steering wheel counter-clockwise while
holding the trigger to turn left.
If the steering is not tight enough, increase the travel
volume as described in the following section.