RAE-SAN DRAFT D, Руководство по установке

Страница: 8 / 20

Page:8
Right UP Double press Kill Toggle - -
Short press Heater Up Heater Up Starter Heater Up
Medium press Lights Toggle Heat Grip
Toggle Kill Toggle Heat Grip
Toggle
Long press Heat Grip
Toggle Lights Toggle - Lights Toggle
Right DOWN Double press Right Merge - - -
Short press Right Indicator Kill Toggle Right Indicator Kill Toggle
Medium press Starter Right Indicator Lights Toggle Right Indicator
Long press - Starter Modulation
Toggle Starter
Heated Grip Function
The Heated Grips function provides drive to heated grips using the stock controls – so you don’t need to add
any extra buttons.
The Heating can be turned on and off and adjusted in level with the number of heat steps being configurable.
The system remembers the last heat setting and returns to it when turned on.
The Heated grip output is a PWM so could be used to drive some other variable function if required.
The heated grip duty cycle talks into account the power relationship to voltage and is calculated to give
equal heating steps.
If disabled in the configuration menu – the Heated grip function will be inoperative.
Using the normal controls the heated grip function uses the starter button –

when the Gated input is active to allow starting – i.e., in Neutral or the clutch is pulled in then the
Starter button will work as the starter button.

If however the Gate input is not active – i.e. normal running mode, clutch out and not in Neutral –
then pressing the starter button will be interpreted as a Heated Grip control command

The Heat setting increases one step on each press and cycles around to minimum from maximum.
Function Normal Mode 4 Button Mode
Toggle Heated Grips ON / Off Starter Button Long Press > 3.5s < 10s
with Gate Inactive Medium or Long Press of Right Up –
see 4 Button Mode table
Increase Heat One Step – Cycles around Starter Button press short press > 0.3s <
1.0s
with Gate inactive
Short press Right Up –
see 4 Button Mode table