MNC-0400-001
28 of 54
REV H
Operation, Rack and Digital HPAs
[Softkey 3]—
Pressed to test the summary fault circuit. The
Summary Fault relays will switch; the Summary Fault LED will
change state and high voltage will momentarily go off.
[Softkey 4]—
Pressed to test the waveguide arc fault circuit. The
fault line on the amplifier will change state.
(This is only
applicable if W/G Arc detection installed)
Note
Press [
Enter
] to move back one level in the setup menu system. Press
[
Status1
] or [
Status2
] to exit the setup menu system.
Setup 2 Menu
Setup 2 Menu
, Figure 11 provides access to these submenus:
Press
[Softkey 1]
to access the Constant Power Menu —This
menu allows the amplifier to be configured for automatic control
of the RF output power level.
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
