Radyne RCS11, Инструкция по установке и эксплуатации

Страница: 15 / 60

RCS11 1:1 Redundancy Switch Installation
TM061 Rev. 1.3 Page 2-1
Section 2 - Installation
2.0 Installation Requirements
This chapter instructs the user in the methods for setting up and installing an RCS11 1:1
Redundancy Switch into a Satellite Modem system. The cabling configurations for two DMD2400
Satellite Modems, two DVB3000 Digital Video Modulators and two DMD15 Satellite Modems are
shown.
2.1 Unpacking the System
Unseal the shipping cartons taking care not to damage the cartons, the packing material or the
equipment inside. The cartons and the packing material should be saved in the event that an
RCS11 will need to be reshipped. Examine the exterior of the units for any possible shipping
damage.
2.1.1 List of Items
Carefully remove the units from the cartons. In addition to this manual, be sure that the following
items are present:
•
RCS11 1:1 Redundancy Switch
•
Two AC Power Cords
•
1:1 Switch System Test Data Sheet
•
RCS11 Standard Cable Set
•
Optional ES/ES Interconnection Cables
•
75-Ohm Splitter
2.1.2 In Case of Shipping Damage
If any shipping damage is discovered to any of the above listed equipment, promptly contact the
transporter and file a damage claim. The transporter is responsible for any damage caused during
shipping. Radyne Corporation should also be contacted.
Damage as a result of transport is not covered under the Radyne Corporation Warranty. Refer to the
Warranty section in the front of this manual for further information.
The procedure for returning faulty or damaged equipment is contained in the warranty section in the
front of this manual.
2.1.3 Test Data Sheet
Each RCS11 1:1 Redundancy Switch system is shipped with a Test Data Sheet. This report contains
information on the results of the Switch quality control testing. The report also includes information
pertaining to the system settings that were made at the factory. Radyne Corporation recommends
that the user save this report for future reference.
2.2 Site Considerations
Adequate site planning and preparation simplifies the installation process and results in a more
reliable system.
The user should ensure that the site has adequate electrical power, environmental controls and
protection against sources of electrical radiation and interference.
2.2.1 Power Sources
The power sources should be properly grounded and as free as possible from electrical interference.
The RCS11 employs a dual redundant power supply configuration. Each power cord on the RCS11
must be plugged into its own separate power circuit. Each circuit must have its own independent
circuit breaker.