Chapter 3 Configuration
WinLink 1000 Installation and Operation Manual
The Evaluate button becomes enabled when a new rate has been
selected.
Note
11.
A question box pops up, asking if you want to re-evaluate the link.
Click Yes to change the rate or No to keep the existing rate.
Selecting a new air-interface rate causes the system to change
its air-interface rate and commence evaluation of the link
performance at the new air-interface rate. This process of
evaluation takes a few seconds.
12.
Click Next.
The Service Parameters dialog box appears.
Configuring Service Parameters
In the Service Parameters dialog box configure E1/T1 (x1 or x2) and
Ethernet parameters.
Î
To configure E1/T1 and Ethernet:
1.
In the Service dialog box, select one of the following:
E1/T1 – Select the E1/T1 field, if you intend to transmit E1/T1
data and Ethernet data.
The Ethernet BW field shows the remaining bandwidth in Mbps
available for Ethernet. The available bandwidth depends on the
number of E1/T1 ports selected.
Select the Ethernet field, if you intend to transmit Ethernet data
only
3-10
Performing Configuration of WinLink 1000
