WinLink 1000 Installation and Operation Manual
Chapter 2 Installation and Setup
Installation and Setup
2-7
Î
To connect the power IDU-E:
1.
Connect the 2-pin plug of the AC/DC converter to the 2-pin DC
power connector on the IDU-E rear panel.
2.
Connect the AC/DC converter 3-prong plug to mains outlet.
Î
To connect the power for IDU-C:
•
For AC power model, connect the AC cable 3-prong plug to mains
outlet.
•
For DC power model, connect to DC supply on the rack (male
connector for the terminal block is included).
Installing WinLink 1000 Management Software
WinLink 1000 management application is distributed on CD-ROM as an
executable file. The application has the following PC requirements:
•
Memory: 128 MB RAM
•
Disk: 1 GB free hard disk space
•
Processor: Pentium 3 or higher
•
Network: 10/100BaseT NIC
•
Graphics: Card and Monitor that supports 1024
×
768 screen
resolution with 16 bit color
•
Operating system: Windows 2000/XP
•
Microsoft Explorer 5.01 or later.
Î
To install the WinLink 1000 management program:
1.
Insert the CD-ROM into your CD-ROM drive.
2.
If the installation does not start automatically, run WinLink.exe
from the CD-ROM drive.
3.
Follow the on screen instructions of the installation wizard to
complete setup of the WinLink 1000 Management program in the
desired location.
Î
To perform initial setup:
1.
Power up the site A's IDU (see
Connecting the Power
on page
2-6
).
Wait about 1 minute.
2.
Power up the site B IDU.
