RadTech 21700001, Руководство пользователя

Страница: 19 / 52

ASSEMBLY
[17]
Determining Driveline Length
IMPORTANT: Before using the equipment,
make sure the driveline is not too long. At
working, the two half drivelines must intersect
each other sufficiently to insure maximum
efficiency but there must not be any
interference.
1. Figure 4: To determine the "L" length for
your tractor model first find the "X" factor
by measuring the horizontal distance
between the end of the tractor's drive shaft
and the end of the snowblower's driven
shaft when the snowblower is in transport
position as shown in figure.
2. Choose in the table below the "Y" factor
according to the driveline series and deduct
that number from
"X" measured previously
to determine "L" (fig.7) which is the center-
to-center length between the universal
joints.
NOTE : The driveline series is inscribed on the
plastics guards.
L = X – Y
DRIVELINE SERIES
Y
MINIMUM
CROSSING
20 Series 4 1/2" 5 1/4"
40 and 50 Series 5 1/2" 7 1/2"
Figure 4