RADLEY YFG52-H, Руководство пользователя

Страница: 14 / 30

13
GAS-LITER TWO-STROKE OIL· LITER ( 2% / 1:50)
1 0.02
2 0.04
3 0.06
4 0.08
MIXING
Always mix the gasoline and oil in a clean container intended for fuel.
Always start by filling half the amount of the gasoline to be used. Then add the entire
amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of gasoline.
Mix (shake) the fuel mixture thoroughly before filling the machine's fuel tank.
Do not mix more than one month's supply of fuel at a time. If the machine is not used for
some time, the fuel tank should be emptied and cleaned.
WARNING!
The catalytic converter muffler gets very hot during and after use. This
also applies during idling. Be aware of the fire hazard, especially when working near
flammable substances and/or vapors.
WARNING!
Taking the following precautions, will lessen the risk of fire: Do not
smoke or place hot objects near fuel. Always shut off the engine before refueling. Always
stop the engine and let it cool for a few minutes before refueling. When refueling, open
the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap
carefully after refueling. Always move the machine away from the refueling area before
starting.
CHAIN OIL
CAUTION!
Before starting the saw, remove the oil tank cap and add bar and chain oil.
NOTE!
1. The service life of saw chains and guide bars depends to a large extent on the quality
of the lubricant used.
2. Old oil must not be used! Use only environment friendly chain lubricant.
3. Store chain lubricant only in containers which comply with the regulations.
4. Use 10W30 motor oil all year round, or 10W30 or 10W40 in the summer and 10W20 in
the winter.