RADLEY YFG52-H, Руководство пользователя

Страница: 17 / 30

5240-174
20" 52CC CHAINSAW
16
CHAIN BRAKE
To release the brake, pull the front guard up toward the
front handle till "click" sound is heard (Figure 14).
1. Break
2. Released
3. Operated
STOPPING THE ENGINE
1. Release the throttle lever to allow the engine to idle
for a few minutes.
2. Put the switch to the stop position (Figure 15).
SAWING
WARNING! It is not necessary to force the saw into
the cut. Apply only light pressure while running the
engine at full throttle.
When the saw chain is caught in the cut, do not force it
out. Use a wedge or a lever to open the way.
Figure 14
Figure 15
GUARD AGAINST KICKBACK
(Figure 16)
This saw is equipped with a chain brake that will
stop the chain in the event of a kickback if operating
properly. You must check the chain brake operation
before each usage by running the saw at full throttle for
1-2 seconds and pushing the front hand guard forward.
The chain should stop immediately with the engine at
full speed. If the chain is slow to stop or does not stop,
replace the brake band and clutch drum before use.
Figure 16
The chain should stop immediately with the engine at full speed. If the chain is slow to
stop or does not stop, replace the brake band and clutch drum before use.
It is extremely important that the chain brake be checked for proper operation before
each use and that the chain be sharp in order to maintain the kickback safety.
Removal of the safety devices, inadequate maintenance, or incorrect replacement of the
bar or chain may increase the risk of serious personal injury due to kickback.