Version 1.0
Page 25
GB
Installing Your Receiver
5
Installing Your Receiver
CAUTION:
Do not place the receiver near any heat sources or in strong sunlight.
Protect all cables from damage caused, for example, by sharp edges.
This appliance must only be used with a mains voltage of 230 V (± 10%), 50 Hz.
CAUTION:
Do not connect the receiver to the mains until you have correctly connected your
VCR, TV and any other analogue receiver you may have to the mains.
•
Use double shielded coaxial cable for connecting the LNB to the receiver.
CAUTION:
When assembling the F-type connector, make sure that no part of the inner wire-
mesh sheath touches the inner core (see diagram below). Failure to do so can
cause a short-circuit and damage your receiver.
Core
Bent Wire
Wire mesh
•
Tighten the safety nut on the F-type connector by hand only. Do not over
tighten!
The receiver is pre-programmed at our factory to immediately provide you with
hundreds of different channels. Of course you can change these channels or
replace them completely. In order to take advantage of all of the user guides such
as programme, you will need to make a number of settings which are described
in the following chapters.
