RadioLink Electronic Ltd
7
When using other brand transmitters, please refer to the following picture to switch the flight modes.
The value range of channel 5 and channel 7 corresponding to the flight mode is as shown below:
Power-on and Gyro Self-test
(1) Push the throttle stick of the transmitter to the lowest position first, and then power on the aircraft. If
the throttle stick is pushed to the highest position and then power on the aircraft, the ESC will enter the
calibration mode.
(2) Each time the flight controller is powered on, the gyro of the flight controller will perform self-test with
the green LED quickly flashing, which means gyro self-test is under process. Therefore, it is
recommended to install the battery first, then place the aircraft on the ground, and then power on the
aircraft and put the aircraft still on the ground until DEE sounds from the motor heard. When the green
LED is always on means self-test is done.
Attitude Calibration
Flight controller Byme-A V2.0 needs to calibrate the attitudes/level to ensure the balance status.
(1) The aircraft can be placed flat on the ground when performing attitude calibration. It is advised to lift
the model head with a certain angle(20 degree is advised) for beginner to ensure the calibration accuracy
and attitude calibration will be recorded by flight controller once the it is complete with success.
