© 2015 Radiodetection Ltd
2
Section 1 - Preface
Before you begin
Thank you for your interest in Radiodetection’s
RD8100
™ cable and pipe locator.
The RD8100 delivers the latest in locating technology in
a powerful yet ergonomic and light-weight design.
Please read this user manual in its entirety before
attempting to use the RD8100 system.
Radiodetection products, including this manual, are
under continuous development. The information
contained within is accurate at time of publication;
however the RD8100, this manual and all its contents
are subject to change.
Radiodetection Limited reserves the right to modify the
product without notice and some product changes may
have taken place after this user manual was published.
Contact your local Radiodetection dealer or visit
www.radiodetection.com
for the latest information about
the RD8100 product family, including this manual.
1.1 Important notices
General
The performance of any cable and pipe locator may be
affected when used in close proximity to ferrous
materials such as manhole covers, steel-toe boots,
mobile phones and nearby vehicles. Keep a distance of
one or two meters from these objects when taking critical
measurements such as depth and current readings.
This instrument, or family of instruments, will not be
permanently damaged by reasonable electrostatic
discharge and has been tested in accordance with IEC
801-2.
However,
in
extreme
cases
temporary
malfunction may occur. If this happens, switch off, wait
and switch on again. If the instrument still malfunctions,
disconnect the batteries for a few seconds.
Safety
WARNING! Failure to comply with safety warnings
can cause serious injury or death
CAUTION!: Failure to comply with safety cautions can
result in damage to equipment or property
This equipment shall be used only by qualified and
trained personnel, and only after fully reading this
Operation Manual.
WARNING! Direct connection to live conductors is
POTENTIALLY LETHAL. Direct connections to live
conductors should be attempted by fully qualified
personnel only using the relevant products that allow
connections to energized lines.
WARNING! The transmitter is capable of outputting
potentially lethal voltages. Take care when applying
signals to any pipe or cable and be sure to notify other
technicians who may be working on the line.
WARNING! Reduce audio level before using
headphones to avoid damaging your hearing.
WARNING! This equipment is NOT approved for use
in areas where hazardous gases may be present.
WARNING! Before removing the transmitter battery
pack, switch off the unit and disconnect all cables
WARNING! The RD8100 locator will detect most
buried conductors but there are some objects, including
live objects, which do not radiate any detectable signal.
The RD8100, or any other electromagnetic locator,
cannot detect these objects so proceed with caution.
There are also some live cables which the RD8100 will
not be able to detect in Power mode. The RD8100 does
not indicate whether a signal is from a single cable or
from several in close proximity.
CAUTION: The battery cover, the accessory cover and
the headphone cover protect the
locator’s sockets from
debris and water ingress. If they get damaged or lost,
contact
Radiodetection
or
your
local
service
representative for a replacement one.
Batteries
WARNING! Batteries can get hot after prolonged use
at full output power. Take care while replacing or
handling batteries.
WARNING! Do not tamper with, or attempt to
disassemble the battery packs.
CAUTION: If battery failure is suspected return the entire
unit to an authorized repair center for investigation and
repair. Local, national or IATA transport regulations may
restrict the shipment of faulty batteries. Check with your
courier for restrictions and best practice guidelines. Your
local Radiodetection representative will be able to direct
you to our authorized repair centers.
WARNING: Exposing the battery to a high
temperature above 60°C (140°F) may activate safety
systems and cause a permanent battery failure.
