Page
17
of
32
©
2019 Radiocrafts AS
RC232 User Manual (ver 2.01)
RC232 USER MANUAL
Command
Details
Comments
ASCII
hex
‘@RC’ 0x40
0x52
0x43
Reset Configuration Memory to factory defaults
This command will reset the configuration memory to the
factory defaults.
Argument
Options
Returns
(none)
(none)
Prompt (>)
At the same time as you run this command you must also
assert the Config pin on the module. This is an extra safety to
avoid unintended resets to factory default.
Caution!
The @RC-command is
writing to NVM/flash, and
this operation must not be
interrupted by for
example a reset or
powercycle. Interrupting
the NVM update may
leave the configuration
memory corrupted.
Caution!
The NVM also
has a limited number of
writecycles (10000x), and
we therefore strongly
recommend that you do
not use the @RC-
command “in field”, only
when configuring and
testing your module as
development or as part of
your production test.
@’RR’ 0x40
0x52
0x52
Reset
This command will reset the module. It has the same effect as
pulling the reset pin low.
Argument
Options
Returns
(none)
(none)
(none)
At the same time as you run this command you must also
assert the config pin on the module. This is an extra safety to
avoid unintended resets to factory default.
‘0’
0x30
Test Mode 0
– List configuration Memory
This command will list all the contents of the non-volatile
configuration memory.
Argument
Options
Returns
(none)
(none)
Configuration
memory
+Prompt (>)
‘1’
0x31
Test mode 1
– TX Carrier
Argument
Options
Returns
(none)
(none)
Prompt (>)
Note!
Before using test
mode 1 you need to send
a normal package so that
