RC1xxx-xSM-DK
2018 Radiocrafts AS
RC1xxx-xSM-DK User Manual (rev. 1.20)
Page 15 of 20
Radiocrafts
Embedded Wireless Solutions
Sensor Board PCB and Assembly Layout
The PCB is a simple 4-layer board where Layer 2 is used as ground plane. The laminate used
is standard FR-4 board material. The PCB is 1.6mm thick. Full resolution layout and assembly
drawing are found in [8]
Figure 6. Sensor Board PCB component placement, top side
Programming/debug connector
Programming debug connector (P14) is connector with 1.27mm pitch. This can be used for
firmware upgrade. A CC-debugger programming device is needed to upgrading.
Sensor Board Circuit Diagram
The circuit diagram of RC1xxx-xSM-SB is in figure 6. For better quality please see PDF in [8]
