Radiocrafts
Embedded Wireless Solutions
RCxxxxHP-DK
2020 Radiocrafts AS
RCxxxxHP-DK User Manual (rev. 3.04)
Page 4 of 13
Development Board Introduction
The Development Board contains USB connector, USB to serial converter, buttons, LEDs,
voltage regulator, configuration jumpers and connectors to make it easy to interface the
onboard module with various test equipment or the host MCU used in an application. Not all
components are needed in an actual application. Please see the datasheet for each specific
module for a typical application circuit.
The module on the Development Board is as default at power-up configured with a channel in
the frequency band where high output power is allowed.
For RC1180HP-RC232 / -TM in particular: The allowed band for 500 mW (+27 dBm)
operation is 869.400-869.650 MHz if configured for another channel, be sure to program the
maximum allowed output power according to the datasheet, never exceeding +14 dBm
outside the mentioned frequency band.
Figure 2: RC11xxHP-DB Development Board
P4:
Antenna
connector
P13: Digital
I/O connector
P12: DC Jack
Voltage
regulator
High power
module
P8: Firmware update
connector
CONFIG
P3: USB LED
jumper
USB LED
Buttons
LEDs
P2: USB connector
P1: RC_VCC
power jumper
RESET
