Radio Systems CT-2002 Desktop Master Driver, Руководство пользователя

Страница: 9 / 28

Radio Systems, Inc. CT-2002 Manual
Page 8
Infra Red Remote Control
(CT-2002 Display units only)
Up Timing
1 Press the Timer Button to place the CT-2002into the Timer Mode. The Timer
Led will illuminate.
(If the “Down” LED is illuminated, press the Reset Button. It may require two
presses.)
2. Press the Start Button to start up timing.
3. Press the Stop Button to stop up timing.
4. Press the Start Button to resume up timing.
5. Press the Reset Button to clear the display.
Down Timing
1. Press the Timer Button. The Timer Led will illuminate.
2. Using the numeric keypad, enter a down time. The Set Led and Down Led
will illuminate. Hours can be from 00 to 99, minutes from 00 to 59 and sec-
onds from 00 to 59. Erroneous entries can be overwritten or the Reset Button
can be used to zero the display. An invalid time such as 12:60:00 will be
cleared when the Start Button is pressed.
3. Press the Start Button to begin down timing. (The down timer can be set to
either stop at zero or continue to count negative. See IR Remote Setup
Functions - see page 10.)
4. Press the Stop Button to stop down timing.
5. Press the Start Button to resume down timing.
6. Press the Reset Button once to recall the entered down time. Repeat steps 3
through 6 as desired.
7. Press the Reset Button two times to exit the down mode (and to clear the
display and return to up timing mode).
Storing Down Times
The IR Remote Control can be used to store up to six down times. These times are
saved when power is removed from the CT-2002.
1. Press the Timer Button. The Timer Led will illuminate.
2. Using the numeric keypad, enter a down time. The Set Led and Down Led
will illuminate. Hours may be from 00 to 99, minutes from 00 to 59, and sec-
onds from 00 to 59. Erroneous entries can be overwritten or the Reset button
can be used to zero the display.
3. Press one of the Store Buttons. If the time entered was valid, the display will
momentarily flash, the Set Led will extinguish and the down time will be
stored. In addition, the entered down time will remain on the display and the
Down Led will remain illuminated. However, an invalid time (such as
12:60:00) will be cleared when a Store Button is pressed. In addition, the
CT-2002 will return to the Up Timer Mode.
4. Repeat steps 2 and 3 as desired.