
NOTE: If you installed rechargeable nickel-cadmium batteries in the
scanner, remove the cap from the CHG jack and connect the AC adapter
to the jack. This powers the scanner and recharges the batteries at
the same time (see "Charging Nickel-Cadmium Batteries").
2. Connect the adapter's power module to a standard AC outlet.
Using Vehicle Battery Power
You can power your scanner from your vehicle's battery power using an
optional DC auto adapter, such as Cat. No. 270-1560 (not supplied).
CAUTIONS: The scanner is designed to work in a vehicle that has a 12-volt
DC, negative-ground electrical system. If you are not sure
about your vehicle, check with your vehicle's dealer.
The recommended DC auto adapter supplies 9 volts and delivers
at least 300 milliamps. Also, its center tip is set to negative
and its plug properly fits the scanner's PWR and CHR jack.
Using an adapter that does not meet these specifications could
damage the scanner or the adapter.
To protect your vehicle's electrical system, be sure you connect
the adapter to the scanner before you connect it to the
cigarette-lighter socket. Then disconnect the adapter from the
cigarette-socket before you disconnect it from the scanner.
1. Set the adapter's voltage switch to 9V.
2. Connect the adapter's orange barrel plug to the adapter's cable with
the tip set to - (negative).
3. Plug the adapter's barrel plug into PWR.
NOTE: If you installed rechargeable nickel-cadmium batteries in the
scanner, remove the cap from the CHG jack and connect the DC auto
adapter to the jack. This powers the scanner and recharges the
batteries at the same time (see "Charging Nickel-Cadmium
Batteries").
4. Plug the other end of the adapter into your vehicle's cigarette-
lighter socket.
NOTE: If the scanner does not operate properly with a DC auto adapter
connected to your vehicle's cigarette-lighter socket, you might
need to unplug the adapter and clean the socket to remove ashes and
other debris.
Preparation
CONNECTING THE SUPPLIED ANTENNA
1. Connect the supplied flexible antenna's BNC connector to ANT on top
of the scanner.
2. Press down and rotate the base of the antenna clockwise until the
antenna locks into place.
CONNECTING AN OPTIONAL ANTENNA
Содержание Pro-60
Страница 1: ......