
batteries.
NOTE: You can use the PWR jack when either chargeable or non-rechargeable
batteries are installed.
The CHG jack lets you connect an external AC or DC adapter to
operate the scanner. When you connect an adapter to the CHG jack,
the internal batteries remain connected and get recharged.
WARNING: Never use the CHG jack when non-chargeable batteries are
installed. If you try to recharge non-rechargeable batteries,
they could get very hot and might explode or leak acid.
CHARGING NICKEL-CADMIUM BATTERIES
The scanner has a built-in charging circuit that lets you recharge nickel-
cadmium batteries while they are in the scanner.
To recharge the batteries while they are in the scanner, simply connect
an AC or DC adapter into the scanner's CHG jack (see "Using Standard AC
Power" or "Using Vehicle Battery Power").
Charging Tips
It takes about 10 to 18 hours to recharge batteries that are fully
discharged. You can operate the scanner while recharging nickel-cadmium
batteries, but the charging time is lengthened.
Nickel-cadmium batteries last longer and deliver more power if you
regularly let them fully discharge. To do this, simply use the scanner
until the low battery indicator appears on the display. Then fully
charge the batteries.
IMPORTANT: This product is capable of using rechargeable nickel-cadmium
batteries. At the end of the batteries' useful life, they
must be recycled or disposed of properly. Contact your local,
county, or state hazardous waste management authorities for
information on recycling or disposal programs in your area.
Some options that might be available are: municipal curb-side
collection, drop-off boxes at retailers, recycling collection
centers, and mail-back programs.
Using Standard AC Power
You can power your scanner from a standard AC outlet using an optional
AC adapter, such as Cat. No. 273-1665 (not supplied).
WARNING: Do not use an AC adapter's polarized plug with an extension cord,
receptacle, or other outlet unless the blades can be fully
inserted to prevent blade exposure.
CAUTIONS: The recommended AC adapter supplies 9 volts and delivers at
least 300 milliamps. Also, its center tip is set to negative
and its plug properly fits the scanner's PWR and CHR jack.
Using an adapter that does not meet these specifications could
damage the scanner or the adapter.
Be sure you connect the AC adapter to the scanner before you
connect it to a standard AC outlet. Then disconnect the adapter
from the AC outlet before you disconnect it from the scanner.
1. Plug the adapter's barrel plug into PWR.
Содержание Pro-60
Страница 1: ......