4
Notes:
If your home has specially wired alarm equipment connected to the
telephone line, be sure that installing the system does not disable your
alarm equipment.
If you have questions about what will disable alarm equipment, contact
your telephone company or a qualifi ed installer.
The base’s location affects the handset’s range. If you have a choice of several locations, try
each to see which provides the best performance.
Your telephone connects directly to a modular telephone line jack. If your telephone wiring
does not have a modular jack, you can update the wiring yourself using jacks and adapters
(available at your local
RadioShack
store), or have the telephone company update the
wiring for you. You must use compatible modular jacks that are compliant with Part 68 of
FCC Rules.
Note:
The USOC number of the jack to be installed is RJ11C (or
RJ11W for a wall plate jack).
On a Desk Top
On a Desk Top
1.
Plug one end of the supplied long
modular cord into the
TEL LINE
jack
on the back of the base.
2.
Insert the supplied AC adapter’s
barrel plug into the
DC IN 9V
jack
on the back of the base and route
the adapter’s cord through the strain
relief slot on the base.
3.
Plug the other end of the modular
cord into a modular phone line jack.
4.
Plug the adapter into a standard AC outlet. To avoid injury, do not connect the
provided power adapter to a ceiling outlet.
CAUTION:
You must use a Class 2 power source that supplies
9V DC and delivers at least 350 mA (for the base) / 210 mA
(for the charging cradle). Its center tip must be set to positive
and its plug must fi t the phone’s DC IN 9V jack. The supplied
adapters meet these specifi cations. Using an adapter that does
not meet these specifi cations could damage the phone or the
adapter.
Installing the Charging Cradle
Installing the Charging Cradle
1.
Insert the supplied AC adapter’s barrel plug into the
DC IN 9V
jack on the bottom
of the charging cradle.
2.
Route the cord through the strain relief slot and plug the adapter into a standard AC
outlet.
Route the cord
AC outlet
DC IN 9V
AC adapter
(supplied)
Installing/Charging the
Installing/Charging the Battery
Battery Pack
Pack
The phone comes with two rechargeable nickel-cadmium battery packs in the handsets, but
not installed. Before using your phone, you must install the battery packs and charge them
for about 15-20 hours.
IMPORTANT:
The EPA certifi ed RBRC
®
Battery
Recycling Seal on the nickel-cadmium (Ni-Cd) battery
indicates RadioShack is voluntarily participating in an
industry program to collect and recycle these batteries
at the end of their useful life, when taken out of service
in the United States or Canada. The RBRC program
provides a convenient alternative to placing used Ni-Cd batteries
into the trash or the municipal waste stream, which may be
illegal in your area. Please call 1-800-THE-SHACK
(1-800-843-7422) for information on Ni-Cd battery recycling
and disposal bans/ restrictions in your area. RadioShack’s
involvement in this program is part of the company’s
commitment to preserving our environment and conserving our
natural resources.
1.
Press down and slide the battery compartment cover open.
2.
Lift the battery pack out of the compartment.
3.
Plug the battery pack’s connector into the socket in the compartment (the connector
fi ts only one way). Then place the battery pack in the compartment.
4.
Replace the cover.
»
»
TEL LINE
DC IN 9V
TEL LINE
DC IN 9V
