8
sions that include the tone. If two
different groups operate transceivers
in the same area on the same frequen-
cy, they do not hear each other’s
broadcasts if they both use different
quiet codes.
Press
QUIET/Q-SCAN
to turn this fea-
ture on or off.
48,(7
48,(7
48,(7
48,(7
and the code ap-
pear when the feature is on.
Setting a Quiet Code
1. To set the desired channel, follow
Steps 1–3 in “Setting the Chan-
nels” chart on Page 7.
2. Press
QUIET/Q-SCAN
.
48,(7
48,(7
48,(7
48,(7
and
the quiet code flash.
3. Press
¿
/
or
À
/
SKIP
to select
the desired quiet code. (See the
“Quiet Codes” chart on Page 9 for
a complete list of quiet codes.)
4. Press
QUIET/Q-SCAN
to store the
setting.
Notes:
• We recommend that you select
a quiet code from 7 to 30. If you
select a code below or above
that range, you must wait 1–2
seconds after holding down
LOCK/PTT
before you begin
talking.
• If you set the quiet codes for all
active channels to 0, or you do
not set any quiet codes, the
quiet code returns to the default
setting (12).
Temporarily Changing the
Quiet Code
You can temporarily change the quiet
code setting during normal operation,
without permanently storing it in the
transceiver.
1. Hold down
QUIET/Q-SCAN
until
48,(7
48,(7
48,(7
48,(7
and the quiet code flash.
2. Press
¿
/
or
À
/
SKIP
to select
the desired quiet code.
3. Press
QUIET/Q-SCAN.
When you turn off the quiet feature or
the transceiver, the new quiet code is
temporarily stored. When you change
the channel, the code you originally set
during channel set-up resumes. If you
did not set a quiet code, a quiet code
does not appear.
If you did not set a channel’s quiet
code during channel set-up, press
QUI-
ET/Q-SCAN
to set the last displayed
quiet code as the code for the current
channel.
