INTRODUCTION
7 Install
Batteries
INSTALL BATTERIES
The battery cover is located on the back of the remote. Pay close attention to the
direction of the batteries. Align the poles (+ and -) as indicated in the battery
compartment. Remove battery case cover to install the batteries in the remote control.
1. Press firmly on the arrow on the back of the remote to remove the battery
cover.
2. Insert four new 1.5-volt AA alkaline batteries, taking care to align the polarity
symbols ( + and - ) as marked inside the battery case.
3. Replace the battery cover.
Notes:
•
Use only fresh AA alkaline batteries.
•
Do not use rechargeable batteries.
•
Do not mix old and new batteries.
•
Promptly remove old or weak batteries since they can leak chemicals that can
destroy electronic parts.
BATTERY SAVER
If a key on the remote becomes stuck or held for an extended period, the remote will stop
sending IR signal after 30 seconds.
ADJUST CONTRAST
Adjust the contrast on the screen of your new
Guide Remote
. Each time batteries are
removed and replaced in the
Guide Remote
;
you can adjust the contrast on the display
screen to your desired level.
To adjust the contrast level, repeatedly press the left or right arrow keys located
directly below the display screen.
