RADEMACHER RolloTron Comfort 1623 45 19, Руководство по эксплуатации и сборке

Страница: 26 / 88

26
EN
i
15. Initial commissioning with the help of the installation wizard
An installation wizard is available in order to help you
configure the RolloTron Comfort DuoFern quickly and
easily. The wizard automatically guides you through the
configuration process for initial commissioning or after
a software reset (see page 73).
Quitting the installation wizard.
Pressing the [ M ] key for 2 seconds causes the installation
wizard to be cancelled prematurely.
Readiness for operation
The RolloTron Comfort DuoFern is ready for use as soon as
the installation wizard has finished.
In addition, you can individually customise your settings
and make changes at any time from the main menu and
the system settings menu.
Additional information about configuring the end
points
The end points must be configured in order for the roller
shutters to stop at the desired upper and lower positions.
It is imperative that both end points are configured,
otherwise malfunctions may occur.
IMPORTANT
◆
If the RolloTron Comfort DuoFern is operated without
an end point setting, the drive will continue to run
for as long as one of the two control keys is actuated.
◆
The automatic functions remain blocked until the end
point setting is configured.
◆
Do not set the upper end point right up to the limit
stop.
◆
Please ensure that the belt is not excessively slack when
reaching the lower end point.
◆
Release the key promptly and never allow it to extend
beyond the respective end point. Failure to do so can
cause overloading and may damage the roller shutters
and / or drive.
NOTE
◆
After a period of time it may be necessary to reconfig-
ure the end points as the belt may elongate during the
process of operation due to stretching.